AuraSonics Source 5 — new five-inch monitors from AudioProject
Grigory Liadov
The Russian distribution company AudioProject is expanding its professional speaker range under its own AuraSonics brand. The new Source 5 active monitors went on sale in early 2024. Unlike the earlier AuraSonics KN4, these are proper professional speakers for studio audio work. Each cabinet has its own powerful, reliable Class AB amplifier, with separate woofer and tweeter channels. Convenient combo XLR/TRS inputs and several room-adjustment controls complete the design.
For now, the five-inch Source 5 is the only AuraSonics model of this type. This is one of the most popular nearfield studio formats, offering useful frequency coverage without excessive demands on room acoustics.
Let us examine this interesting new model more closely.
AuraSonics Source 5 specifications
| Drivers | |
| Woofer | 5,25" |
| Cone | Composite fiberglass |
| Tweeter | Fabric dome tweeter |
| Driver size | 1" |
| Amplifier | |
| Amplifier type | Analog, Class AB |
| Power | 80 W (45 W + 35 W) |
| Maximum SPL | 102 dB |
| Connections | |
| Balanced | XLR/TRS |
| Unbalanced | RCA |
| Controls | |
| Volume control | Front panel |
| Volume control modes | Two modes, plus bypass |
| Volume control mode indication | Color-coded |
| Signal level indication | Peak level |
| Treble equalization | 10 kHz, ±6 dB |
| Midrange equalization | 1 kHz, ±6 dB |
| Bass equalization (Acoustic Space) | 800 Hz: 0 dB, -2 dB, -4 dB |
| High-pass filter | Off / 80 Hz / 100 Hz |
| Other specifications | |
| Frequency range | 52 Hz–20 kHz |
| Cabinet | MDF, vinyl laminate finish |
| Dimensions | 178 x 260 x 200 mm |
| Weight | 4.6 kg |
The Source 5 has an MDF cabinet with a vinyl laminate in the brand's blue color. Its plastic front panel has recognizable waveguides around the drivers. A bass-reflex slot port sits low on the front. This forward-facing port allows placement close to a wall.
The 5.25-inch woofer uses a composite fiberglass cone. Actual cone diameter, including the rubber surround, is 11.5 cm.
The Source 5 tweeter is a common fabric dome design. A metal grille protects its diaphragm.
A front power indicator and volume knob make operation convenient. The knob has three modes. Normal mode adjusts from silence to +6 dB. A finer mode covers -18 dB to +6 dB for more precise matching. Bypass disables the knob so an audio interface, mixer, or other connected device controls level. The indicator identifies each mode: green for normal, blue for fine adjustment as shown in the photo, and off for bypass. It also turns red to indicate clipping.
Flexible mounting is a distinctive Source 5 feature. Included self-adhesive rubber pads isolate the monitor from a desk or other surface. A metal 3/8-inch threaded socket underneath allows stand mounting. Rear holes also support VESA brackets.
VESA compatibility permits many bracket types, from wall to ceiling mounts. Use a 100 × 100 mount with enough cable clearance. The monitor weighs 4.6 kg, so the bracket must support that load and lock its tilt angle securely.
The metal rear panel supports VESA mounting and dissipates some heat from the amplifier heatsink inside. Combo TRS/XLR sockets accept balanced signals, while RCA provides unbalanced connection.
The SOURCE5 offers unusually extensive controls for an inexpensive studio monitor. Equalization covers all frequency ranges. HIGH and MID knobs adjust treble and upper midrange. LOW CUTOFF selects the high-pass filter mode. ACOUSTIC SPACE reduces bass according to placement. Our measurements will show what each adjustment does.
Inside, construction looks as good as outside. Sealant closes all joints and connections. The tweeter has a separate isolated compartment. Thick polyester fiber lines the cabinet walls.
The analog amplifier uses two TDA7294 chips. Each can deliver around 60 W with distortion below 0.1%. Foam covers the wires to prevent unwanted noises, and sealant secures the connectors.
A large transformer supplies the amplifier's required voltage.
Measurements
Our measurements use the hardware and software measurement system RightMark™ Audio Analyzer PRO. We also use the measurement microphone Earthworks M50, with the following specified data:
- Microphone serial number: 92901C
- Microphone sensitivity at 1 kHz: 26.4 mV/Pa
- Microphone frequency-response variation from 20 Hz to 20 kHz: 0.2 dB
- Microphone frequency-response variation from 3 Hz to 50 kHz: +1/−3 dB (roll-off from 45 kHz)

Frequency response with neutral tone settings
Our measurements show 60 Hz–30 kHz coverage within ±6 dB. The controls can reduce variation further, but this has little practical value. More importantly, the response is smooth and variation within the operating range stays within ±3 dB. Bass starts around 70 Hz, a good result for five-inch speakers.

Frequency response at different tone settings
Treble adjustment starts at 1 kHz and reaches the specified ±6 dB by 10 kHz.

Frequency response at different tone settings
MID equalizes the region around 1 kHz. Measurements show an affected range of about 300 Hz–3 kHz.

Frequency response at different high-pass settings
LOW CUTOFF helps integrate the monitors with a subwoofer by selecting the high-pass cutoff. Flat bypasses the filter. The 80 Hz and 100 Hz settings reduce low bass for better subwoofer integration. The measurements clearly show the filter's effect.

Frequency response at different Acoustic Space settings
Acoustic Space reduces the lower register according to placement. The manufacturer suggests -4 dB in corners and -2 dB near a wall. Unlike the high-pass filter, this control reduces the lower range evenly across its frequencies.
Sound
The AuraSonics Source 5 sounds good. It has the clear, full presentation expected of modern small monitors. Sound quality is high for inexpensive studio speakers, supporting tasks from synthesizer playback to tonal work and equalization. Its sound differs greatly from the first models AuraSonics KN4 and fully suits studio use.
The monitors sound best at medium and high levels, where the drivers produce a fuller, more even tonal balance. Detail is slightly limited, but highly detailed monitors are not available in this entry-level price range. Even at high levels, the Source 5 retains its detail and stays reasonably clean, setting it apart from some competitors.
We think the Source 5 makes full use of its drivers. They are well integrated, with no tonal gap around the crossover. Bass is full, and the port supports it gently without obvious booming artifacts. Treble is also good, without unusual character or clear weaknesses.
The many controls deserve attention. Although each acts only on certain frequencies, they allow useful changes for different rooms and listening preferences.
Conclusions
The AuraSonics Source 5 from Russian company AudioProject is an excellent new monitor. It combines attractive design, sound comparable with leading brands, extensive controls, and an affordable price. We particularly welcomed the reliable analog amplifier and both microphone-stand and VESA mounting options.
Note. This is an adapted machine translation into English. It follows the “In simple terms” approach. Read the original article at https://prosound.ixbt.com/monitors/aurasonics-source5.shtml.









